Support

Quick Start & User Guide

 

A. Included in the Box

  1. Lamp shade attached to LED module

  1. LED controller

  1. Base support 

  1. 1 m USB-A → USB-C cable
     (Power adapter not included — use a 5 V 2 A charger.)

B. Assembly (~1 minute)

  1. Place the lamp upside down
    Place the lamp shade and LED module upside down on a flat, soft surface.

  1. Attach the LED controller
    Align and connect the magnetic connector between the controller and LED module.

  1. Fit the base
    Place the base over the controller, aligning the USB-C port opening and three screw holes.

  1. Secure with screws
    Use three × 35 mm screws. Tighten lightly — do not overtighten.

  1. Connect power
    Plug in the USB-C cable and a 5 V 2 A adapter. The lamp will:
     • Glow orange briefly (startup)
     • Blink blue if in AP mode
     • Blink green if Wi-Fi connected
     It will then return to the last used light effect.


C. Basic Operation

  • Left Button → Cycle through light presets (short press)
  • Right Button → Adjust brightness in 3 levels and off (short press)

D. Advanced Operation

Access-Point (AP) Mode

  1. Power on the lamp.
  2. Connect to Wi-Fi network “komonari”
  3. The setup page opens automatically; if not, visit http://192.168.4.1.
  4. Control presets and brightness, or connect the lamp to home Wi-Fi.

Presets and effects may evolve with future firmware updates.

Connecting to Wi-Fi

  1. Open the control page via AP mode.

  2. Enter your Wi-Fi SSID and password.

  3. The lamp reboots automatically after saving valid credentials.

  4. When connected, it blinks green.

  5. To find the IP address:
     • Use a Bonjour Browser app (available from official Android and Apple App Stores), or
     • Use any network scanner, or
     • Check your router’s connected devices list.

Firmware Updates

  1. Connect the lamp to Wi-Fi.

  2. From the web page, open Settings → Firmware Update.

  3. Upload an official Komonari firmware file.

⚠️ Use only official Komonari firmware. Installing unofficial firmware will void the warranty.

E. Scheduling & Time Sync

Once connected to Wi-Fi, the lamp automatically syncs its clock.
Create schedules such as:
 • Turn on at 7 AM for waking up
 • Turn off at 11 PM for sleep time
 Schedules are managed via the web interface.

 

F. Care & Maintenance

  • Clean with a dry or lightly damp cloth only.
  • Avoid alcohol-based or chemical cleaners.
  • Keep away from heat or direct sunlight.

G. Warranty & Support

  • 1-year limited warranty on electronic components.
  • Warranty void if opened, modified, or tampered with, or if non-official firmware is installed.